iarl писал(а):Это что последняя прошивка 1660 ????????????
Firmware 16.60 for CMD-V4
Author: Wincor Nixdorf International GmbH
Services Division, GCCC 4, Technical Support
Improved closing of the CMD clamp
The handling to close the clamp is changed to make sure that the clamp closes properly.
ECO mode for Cash dispenser
The firmware can be set into an ECO mode in case of longer time periods without transactions. In this
ECO mode only the stand-by-voltages are available. The ECO Mode can be set and reset by the
application. Details available in Service Information SI11093E.
Check of SCOD state before accepting a command
In case of a FW failure with SCOD=01 the response of DBx and DCx commands could be incorrect.
With version 16.60 the SCOD state will be checked before DBx or DCx commands are send and in
case of SCOD=01 response code will be “D”
Retract handling improved in case of power failure
If the CMD clamp is in undefined position after a power failure the note transport belts of the clamp will
move to direction clamp bottom to make sure that all notes are inside the clamp. This behavior solves
problems if power fails during note presenting.
Test note behavior after SCOD=17, 19 or 23
To make sure that all transport ways are free a test note from the lowest cassette will be transported
after RESET if before SCOD 17, 19 or 23 has occurred.
In case of a recovered clamp problem warning code "009019300020ToSh" will be protocolled in the
Waiting time for PS 28 state in self-test
In case an empty clamp was transported to the shutter (self-test case) the PS28 state was checked too
early. This can sporadically cause an error during the test. Now there is a waiting time implemented.
User guide LEDs in ProCash 5000 handled correctly
The user guidance arrows of the ProCash 5000 where not handled correctly in Version 16.52. This bug
bigbag писал(а):на первых ревизиях контролера приводит к постоянному насчёту из кассеты, плюс синг реджект не отключается.
Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 3